Wiki Category: VNAC

SAWRECYCLE: Performed SAWSTOP followed by SAWSTART

The SAWRECYCLE command is complete.

SAWRECYCLE: Performing SAWSTOP followed by SAWSTART

The SAWRECYCLE command is underway.

SAWPRUNE: nn ended sessions pruned from repository at your request

This message gives the number of SAW records (nn) that were pruned as a result of the SAWPRUNE command.

SAWPRINT: Begin print of | End print of SawBuffer

This message announces the disposition of a SawBuffer.

SAWPRINT: Was set to state, now set to state Where Y=Yes=On|Resumed and N=No=Off|Suspended

Using Y(es) and N(o) indicators, this message describes the state change of //VNCSAW recording.

SAWPRINT: Failed to open //VNCSAW file

The //VNCSAW DD could not be opened, probably because it is not present in the VNAC jobstep of the VNAC jobstream. The //VNCSAW DD statement may be specified as follows.

//VNCSAW DD SYSOUT=*

SAWHELP: End Session Awareness Monitor (SAW) help information

This is the final response message to the SAWHELP command.

SAWHELP: SAWSTOP (withdraw permission to use VTAM CNM interface)

SAWHELP: SAWSTAT (display SAW status and statistics)

SAWHELP: SAWSTART (grant permission to use VTAM CNM interface)