Wiki Category: VNC12nn: VNAC Command Prefix

Invalid command: command

Description: The agent subsystem interface received a command work element, but the element contained an unknown command.

Action: Contact SDS Technical Support.

Agent has not connected to subsystem xxxx

Description: The operator issued the SSINFO command to display subsystem information. The agent is configured to connect to subsystem xxxx but is not currently connected.

Action: Review the VNAC agent logs and job log for additional messages that may indicate why the agent did not connect to the named subsystem.

Command Timeout is nnn seconds

Description: The operator issued the SSINFO command to display subsystem information. The subsystem will wait up to nnn seconds for an acknowledgement from the agent before timing out.

Action: None.

CPF scope is scope

Description: The operator issued the SSINFO command to display subsystem information. The scope of the command prefix string is scope where scope is SYSTEM or SYSPLEX.

Action: None.

This agent is configured to use CPF string = cpf string

Description: The operator issued the SSINFO command to display subsystem information. The agent is using the Command Prefix String cpf string.

Action: None.

This agent is configured to use subsystem = xxxx

Description: The operator issued the SSINFO command to display subsystem information. The agent is connected to the subsystem xxxx.

Action: None.

No command prefix string is defined for this agent

Description: The operator issued the SSINFO command to display subsystem information, but the agent is not using a subsystem because the agent GlobalConfig configuration CPF parameter was not specified.

Action: If this is correct, no action is required; otherwise, specify the missing parameter in the agent GlobalConfig configuration section and restart the agent.

No subsystem name is defined for this agent

Description: The operator issued the SSINFO command to display subsystem information, but the agent is not using a subsystem because the agent GlobalConfig configuration SubSystem parameter was not specified.

Action: If this is correct, no action is required; otherwise, specify the missing parameter in the agent GlobalConfig configuration section and restart the agent.

This agent is not using a subsystem because:

Description: The operator issued the SSINFO command to display subsystem information, but the agent is not using a subsystem because of the response listed in the following messages.

Action: See messages VNC1282I  and VNC1283I.

Static subsystems are not supported

Description: While preparing to connect to the subsystem, the agent determined that the target subsystem is defined as a static subsystem. This version of VNAC does not currently support static subsystems.

Action: Change the VNAC agent GlobalConfig startup parameter, Subsystem, to specify the name of an existing, dynamically defined VNAC subsystem, or the name of a subsystem that does not already exist, in which case the agent will define it.